Step 1 - Close Outlet Valve Handle and Inlet Valve Handle Turning Clockwise until perpendicular to pipe.
NOTE: Both Outlet & Inlet Valve Handles are shown in open position.  Turn Clockwise 90 degrees from position shown to close.

Bleed Screw In Open Position


Bleed Screw In Close Position

Step 2 - Close Bleed Screws - Use flat head screwdriver to turn screws 90 degrees to the right to close.  NOTE: see pictures
Step 3 - Close spigot or insert plug.
Step 4 - Turn on water supply for system in basement.  Valve handle located near main water supply or near exit from building to back flow prevention valve assembly.
Step 5 - Open inlet valve handle.  Water will rush to bonnet, snapping closed the check spring for back flow. NOTE: Water will leak out of bonnet for a few moments until check spring closes.
Step 6 - Open Outlet Valve 
SLOWLY  Water should rush to system.
Step 7 - Turn on controller in garage and cycle the system, checking all zones for proper system operation
All FVI systems are put in with a rain sensor (shown left).  During a wet spring, you may need to bypass your rain sensor in order to check system operation. To bypass rain sensor turn cap so indicator on cap meets with indicator on body of rain sensor (much like lining up the arrows on a child safe medicine bottle) and lift to separate.  This disables the kill switch and lets operation of system.

IF YOU HAVE ANY QUESTIONS RELATED TO THIS OR HAVE ANY SYSTEM PROBLEMS OR CONCERNS
 
PLEASE CONTACT FVI, INC. - (920) 437-7990